Sentence examples for be calculated repeatedly from inspiring English sources

The relation between the L-C value and the system time constant are described with the closed form and the filter values must be calculated repeatedly to satisfy the prescribed voltage total harmonic distortion (THD) of the system.

The hazard functions presented here permit simulation of events, so that new estimations can be determined, and expected QALY gains can be calculated repeatedly.

Firstly, the derivatives of the output are calculated repeatedly so that the relative degree of the system is obtained.

In the simulation, joint angles are set as design parameters, and joint torque and muscle force are calculated repeatedly until the objective function becomes the maximum value.

In this process, the ({text{NPV}}_{text{C}}) is calculated repeatedly in an approximately large number of (J) times considering the stochastic prices of coal.

The bending frequencies have been calculated repeatedly while changing the axial load level and the subsequent changes in both frequency and damping ratio, with increasing axial load level have been analysed to determine if the results are statistically significant.

Our statistical test for determining if the addition of an extra sub-type significantly increases the observed heterogeneity signal used a reference distribution in which the differences in the optimal values of D* for the competing numbers of clusters were calculated repeatedly from datasets in which the subject labels were permuted.

After establishing ( {D}_0^{(0)} ) with the vectorization process, ( {D}_l^{ k)} ) at each level can be calculated by repeatedly performing the decomposition process in Eq. (5). Figure 7 shows illustrative results of decomposition by the M-band multiwavelet packet transform of a remote sensing image.

The GCD of three or more numbers equals the product of the prime factors common to all the numbers, but it can also be calculated by repeatedly taking the GCDs of pairs of numbers.

When various non-uniformity configurations are being considered for a given tire, the modal characteristics of the axisymmetric tire may be calculated once and used repeatedly to calculate the vibration characteristics of the non-axisymmetric tire.

For this group, a response rate could not be calculated as recruitment had to be paused repeatedly due to interference with competing clinical trials (unknown denominator).