Finally, in the mitigation module risk profiles for the calculated consequences can be calculated and compared to alternative solutions by assignment of a cost function to the consequences.
Afterward, the dynamics characteristics of the rotor system must be calculated and compared with the experimental results to verify the models.
Using a hypothesis for the ego-motion state, the expected radial velocity can be calculated and compared to the actual measured Doppler velocity.
The residual oil saturation in the core sample is closely related to NMR T 2 signals, and hence the change of the residual oil distribution after water flooding, polymer flooding, and SP flooding can be calculated and compared by analyzing NMR T 2 signals.
Note the similarities between Site 1149 Factor 2 and Site 52 Factor 4 as well as Site 1149 Factor 3 and Site 52 Factor 2. Based on the TI results, the dispersed ash mass accumulation rate (MAR, g/cm2/ky) at Site 1149 can be calculated and compared to the MAR of a series of ash layer parameters.
Using a Lennard-Jones type of potential, U = −Cr6 + Dr12, and assuming pairwise addition, the free surface energy γ of rubber may be calculated and compared with typical experimental values (γ = 35 mJ m−2. From this, a typical value is obtained for C of order 60 × 10−79 J m6 (corresponding to a Hamaker constant ⋍ 9.3 × 10−20J).
These imputed cases were then combined with the experimental geocodes providing a complete data set (geocoded plus imputed nongeocodes) for which case enumerations can be calculated and compared to that obtained using the complete geocoded data set.
