The phrase "baud rate of" is correct and usable in written English.
It is typically used in technical or scientific contexts to refer to the speed at which a data transmission or communication can occur. Example: "The baud rate of this new modem is significantly higher than the previous model, allowing for faster internet connections."
The LCD connects with the MCU using hardware USART and it receives command from the MCU at a baud rate of 2 Mbps.
CAN buses: All CAN buses in the test framework operate independently from each other at a baud rate of 256 Kbit/s.
The main camera is installed on a rotary platform, which has a highest rotary speed of 400°/s, presets 128 positions, and has a baud rate of 9,600 bps.
The Arduino communicates with MATLAB at the baud rate of 57600 bps.
In our experiment, we used a piezoelectric motor controlled OCT probe to provide the motion compensation through a USB com port interface with baud rate of 9600 bits/s.
The important aspect here is the baud rate - make sure it matches the baud rate of your module - check the datasheet or use AT commands to do it.
Unfortunately, traditional systems communicating over RS-485 face a trade-off between cable length, which constitutes one of the most important factors that determine bus loading, and the employed baud rate, to ensure end-to-end signal integrity.
The ULA cannot maintain the display during SAVE and LOAD operations, as it has to operate continuously to maintain the correct baud rate for data transfers.
The RF CMOS transceiver can be supplied with only 1.8 V, and it was designed to establish wireless links for distances up to 10 m, for a maximum baud-rate of 250 Kbps with a Bit Error Probability less than 10−6.
Many man-made communication signals exhibit cyclostationarity with cycle frequency equal to the twice of the carrier frequency or multiples of the baud rate or combinations of these [2].
The three plots below illustrate the average raw performance of the ToLHnet protocol operating on three different lengths of RS-485 cable, as a function of the distance between the nodes involved in the communication and for different choices of the baud rate.
