Sentence examples for based varnish from inspiring English sources

Figure 5 shows a loose sample again of the white ground layer with a red paint layer which appears glossy due to a coating of a resin based varnish (see FTIR results).

This would become problematic if, for example, there was an attempt to establish a Public Health measure such as the implementation of water fluoridation or a school based varnish scheme, which only serves a local or specific area where families may not reside for sufficient time to gain benefit.

Three formulations of propolis - based chitosan varnish (PCV) containing different concentrations (5%, 10%and15%5%) were produced by dissolution of propolis with chitosan on hydro-alcoholic vehicle.

The minimum inhibitory concentration (MIC) and minimum bactericidal concentration (MBC) for cariogenic microorganisms (Table  5) were lower compared with controls EPE, CHV and CHL.> -wrap-foot>> -wrAbbreviationseviations: PCV propolis-based chitosan varnish, CHV chitosan varnish, EPE ethanol propolis extract, CHL chlorhexidine 0.12%, NYS nystatin.

The chitosan base varnish (CHV), used as blank varnish, were prepared by the same method, using ethanol instead of EPE.

This is the first analysis on the impact of increasing fluoride varnish based on evidence-based recommendations and with the use of skill mix.

The properties of the synthetic coatings were compared with those of a traditional varnish (based on alcohol and natural resins) to obtain a better performance.

Thereby, the effect of a desensitizing varnish based on methacrylates on peroxide diffusion was tested.

The floor cloths are made of artists' canvas, painted in latex exterior paint and sealed with a water-based varnish; they can be cleaned with a mop.

For this purpose, prepared Caucasian spruce (Picea orientalis L). specimens were surface treated (synthetic and water-based varnish) after impregnated according to ASTM-D 1413-76 principles with various chemicals (Tanalith-E and Wolmanit-CB).

Thirty-nine dafterftreatmentmenthethe specimens were cut to pieces of 15 × 5 × 2.5 cm3 and sealed at the cut faces using a mixture of Sigillon I and II (polyurethane-based varnish) since these areas are actually not exposed to water in a construction work.