"I consider that it is essential to put the correct information to the Clinical Advisory Group CAGG) and give it ample opportunity to reconsider its conclusions based upon the new figures".
The series average, based upon the viewing figures of the first broadcast of each episode, was 904,000 viewers, or 4.9% of the audience, lower than the slot average of 970,000 (5.1% of the audience).
Based upon those figures, they created a model of avian mortality related to tower height, and then applied it to 70,414 towers exceeding 60 meters (around 200 feet) in height.
Based upon the data in Figure 1, we filter out those probe sets that are not detected in at least one of the treatment groups to be compared before performing statistical comparisons.
To assess the influence of receptor binding affinity and the linear clearance of exogenous rHuEPO analogue on the pharmacodynamic effect, HGB response vs. time profiles were simulated based upon the model in Figure 2a, but with a combination of KDA values ranging from 41.8 to 83,600 mIU/ml, and CLA values ranging from 3.73 × 10−3 to 1 h/l.
Based upon the results in Figure 7, Anc was set to have low variance in latent period at 37°C (SD = 1 min) and high variance at 42°C (SD = 7 min), while Muts have high variance at 37°C (SD = 4 min) and low variance at 42°C (SD = 1 min).
The annotation of the gene variants is based upon the molecular phylogenies in Figures 1A and 2A.
We prepare the figure based upon the numbers listed in the data source.
Based upon the data shown in Figure 2, pGFP-F2A58-CherryFP / pGFP-F2A30-CherryFP were used as exemplars of highly efficient 2A cleavage and pGFP-F2A20-CherryFP / pGFP-F2A18-CherryFP as exemplars of inefficient cleavage.
For GNT1IP-L-CD1, Figure 4C of Huang et al. showed that the C-terminal deletion mutant is mainly retained in the ER, so formation of GNT1IP-L-CD1-MGAT1 heteromershouldld be reduced based upon the results presented in Figure 7 of the current manuscript.
The fluidised bed combustor (Figure 11) is based upon the bubbling fluidised bed design, in which hot air of sufficient velocity (in this apparatus, approximately 0.7 m s-1 for inlet air at 500°C) is injected into a bed of inert particles (e.g. sand) to cause the particle to move dynamically in similar way to a viscous liquid.
