Sentence examples for based on mole fraction from inspiring English sources

The obtained results demonstrated that solubility of cyproheptadine ranged between 3.35 × 10−5 and 3.09 × 10−3 based on mole fraction.

The obtained solubility data were in the range of 1.17 × 10−5 and 5.12 × 10−4 based on the mole fraction (mole piroxicam/(mole piroxicam + mole CO2)) then modeled using four different density based correlations namely Bartle et al., Mendez-Santiago-Teja, Chrastil and Kumar and Johnston models.

A dynamic simulation model of a hollow fiber membrane module has been developed by deriving new transient mole fraction balances, energy balances, and gas velocity equations based on mole balances.

The measured solubility data at the temperature and pressure range of 308.15 338.15 K and 16 40 MPa was ranged between 2.65 × 10−5 and 8.12 × 10−4 based on the mole fraction.

Regarding this fact, solubility of fluvoxamine maleate in supercritical carbon dioxide in wide ranges of temperature (308 338 K) and pressure (200 400 bar) was measured using a static method coupled with gravimetric method which is in the range of 1.23 × 10−5 to 4.45 × 10−4 based on the mole fraction.

Based on the mole fractions and formation temperatures of the detected pyrolysis species, a simple reaction network is deduced.

Based on the mole fractions of H2SO4 for some of the extremely low pH solutions reported by Nordstrom et al.[25] and higher pH solutions more typically found in other AMD areas, the heat from mixing for several hypothetical scenarios can be calculated.

PDL composition was varied based on moles of PDL fed to the reactor divided by the moles of PDL plus DES fed.

Mass per time emission factors were estimated based upon the mole fraction of each pollutant on a dry basis, dry exhaust molar flow rate, and the molecular weight of the exhaust gas.

Based on this strategy, the mole fraction of the fittest increases by (2q)−r times after the rth round.

Empirical relationships based on the NAPL-phase mole fraction and/or micelle-aqueous partition coefficients measured in single-component NAPL systems are developed to estimate values for the multicomponent partition coefficients.