Sentence examples for based on flow rate from inspiring English sources

(2) The pneumatic system is modeled based on flow rate characteristics during the pressurizing and depressurizing of the muscles to analyze the nonlinearity of the driver.

As some parameters are not taken into account in these equations, alternative formulas are proposed which calculate the proper inner diameter size based on flow rate, pressure drop per unit length, CO2 density, CO2 viscosity, pipeline material roughness and topographic height differences (the Darcy Weisbach solution) and, in addition, on the amount and type of bends (the Manning solution).

Nonetheless, the water flow between the two sides of the flume chamber was similar, and preliminary tests altering flow rate between each side confirmed that butterflyfishes did not prefer a chamber based on flow rate.

The results are based on flow rates of 8.0 L/min at the inlet, 1.09 L/min at the outlet, and 6.91 L/min at the aerosol excess outlet.

The sub-clusters division is based on flow conditions (oil rate, WC, and GOR).

In our study, a 90-m DEM was considered adequate due to the unavailability of information regarding lava flow rates in the area and assumed higher flow rates based on flow geometries measured in the field.

The back-off mechanisms proposed in this protocol has an impact on energy consumption, latency, throughput, and packet loss rate based on flow state and varying residual energy.

Based on the flow rate of each segment, the rate distribution of outlet can be obtained Q_{y}^{text{ex}} = frac{1}{m}sumlimits_{i = 1}^{m} {q_{i,n} }. (12).

This concentration is calculated based on the flow rate in the room, CO2 generation rate per person (23.8) according to Egyptian body surface area (1.84 m2) [24] with metabolic rate = 1.2 and outdoor CO2 concentration (380 ppm).

Together with the speed of the droplet in the channel, which has been estimated to be 2 mm/s (based on the flow rate of the fluids), one can extract the kinetics of the reaction in the system.

Based on the flow rate distribution, thermal analyses and thermal hydraulic stability analyses are carried out in order to obtain the available region of the reactor thermal power and the feedwater flow rate for the power-raising phase.