Sentence examples for based devices with a from inspiring English sources

Polymer solar cells with the blend of P1 and PC71BM as the active layer without the additive or annealing showed a PCE of 4.72%, which was higher than P2 based devices with a PCE of 1.65%.

Obviously, P1 can endow devices with a Voc of 0.77 V and a Jsc of 10.75 mA cm−2, which are higher than that of P2 based devices with a Voc of 0.75 V and a Jsc of 4.41 mA cm−2, such an enhanced photovoltaic performance can be attributed to the broader absorption, the improvement of film morphology, and the higher charge mobility.

In addition modu is scheduled to launch in the near future its modu W – a Wi-Fi based device with a touch screen operating on the Android operating system.

So there should be a possibility of substituting some graphene based devices with this a-Gs having further advantage of its simple synthesis procedure as well as gram level higher yield.

Device efficiencies up to 6.4% are achieved with this design, which are the highest efficiencies for P3HT based devices with calamitic NFAs, suggesting that this is an effective design strategy.

The study should be useful in designing various fiber optic multimode interference based devices with high or low temperature sensitivities.

The temperature of the Si clean surface preparation, the final high-temperature step of which is, as a rule, carried out directly in the MBE chamber just before the structure deposition, determines the compatibility of formation process of Ge-QD-array Ge-QD-array Ge-QD-arrayCMOS manufacturing cycle.

In this point of view, it is preferred to use Pt/CFO-2/Pt structures for RRAM applications because most of the CFO-2 based devices are FF with a narrowly distributed V SET, as shown in the first two panels of Figure 6.

The studies employed P3HT PCBM based devices produced with different architectures and methods ranging from spin coating to roll-to-roll manufacturing.

These devices have efficiencies comparable to conventional inorganic semiconductor based devices, coupled with the inherent advantage of having polymers as the active component in the device especially in terms of large area, cost effectiveness, chemical tunability and flexibility.

The solar-to-electric conversion efficiency limitations of state-of-the-art CuInS2 based devices are discussed using a comparison with device simulation.