Sentence examples for base of the lid from inspiring English sources

Pecheux used no foundation or mascara, only eyeliner that led from the inner corner of the eye up and out to show some skin in between another line closer to the base of the lid.

For Newtonian rheology, this means that the plastic zone has to extend through the base of the lid.

However, unlike Solomatov (2004a), we determine the distance to the boundary of the plastic failure zone by measuring it from the base of the lid and scaling it in terms of the rheological boundary layer thickness.

The shear stress τ lid acting on the base of the lid of horizontal length a is balanced by the normal stress τ y acting on the side with depth δ y, developed under free-slip boundary conditions.

At Rayleigh numbers higher than those reached in Solomatov (2004a), the lid is expected to become sufficiently thin so that the heat production inside the lid would be negligible compared to the heat flux at the base of the lid.

In deriving a theoretical scaling for the critical yield stress, we assume an approximate balance between the force generated by the shear stresses acting at the base of the lid and the normal stress acting on the side of the lid and we assume that the latter are largely dominated by the stresses in the plastic zone δ y (Solomatov 2004a and Figure 25).

For those ant species where abundant material was collected, stalks bearing mature stromata were removed from the host, attached at the base to the lid of a plastic Petri dish – previously smeared with a film of Vaseline – and suspended above a dish containing either distilled water agar (DWA) or potato carrot agar (PCA).

Phase 3: An additional plume pulse by a reactivation of the upwelling causes a broad patch of hot material spreading at the base of the thinned lid.

These lashes originate from the base of the lower lid.

Plexiglass sheet (VH-100 Acrylic Resin) was used for the base and the lid of the reactor.

Snap in the on and off switch into the base, secure the lid on top of the battery, push the LED into place, and attach to the soda can.