Sentence examples for base flow values and from inspiring English sources

We researched published base flow values and evaluated several methods of base flow separation.

Period A (till February 4th, 0 30 a.m). is characterized by several hours of heavy rainfall, the 1st increase in discharge (2.0 m2/s) but base flow values of T and EC.

We examined flow duration curves and daily mean flow hydrographs, and, where available, we compared published base flow values to median flow.

Temperature and EC are still characterized by their base flow values in Period A which shows that discharge responds quicker to the recharge event than the physico-chemical properties a phenomena which was reported by other studies (Ryan and Meiman 1996; Birk et al. 2004; Mudarra et al. 2014).

Base flow values of EC are, consequently, a measure of slow matrix flow which allows equilibration with calcite, whereas sharp dips in EC are typically indicative for surface water intrusion through point sources (Birk et al. 2004).

We then calculated sediment yields for 3 years using a process-based SRC method: annual hydrograph was divided into storm and base flows using values of Qt for all seasons and only storm flows were used to calculate sediment yields based on the developed SRCs.

The base flow index (BFI) values for 35 stream gages are obtained from each of the seven methods with each gage having at least two consecutive years of specific conductance data and 30 years of continuous discharge data.

These point values for stream gages were calculated using an automated hydrograph separation technique that partitions each value in a time series of measured daily streamflow into slowly varying (base flow) and rapidly varying (quick flow) components.

Under base flow conditions, the EEQ values in drainage water are either below the level of detection (LOD) or in the lower range of all reported measurements.

The values of n* = 5 and f* = 0.9 were used for this catchment, where the best match between the measured and calculated base flow was found at these values during low flow conditions.

The cyclically flowed nucleotides and the corresponding flow values build the basis for not only base calling, but also per-base quality score calculation (integrated in Titanium output).