Sentence examples for base case with a from inspiring English sources

To highlight the influence of range-dependent parameters and topographic features on sound propagation, four cases are considered: (i) a homogeneous poro-elastic half-space (the base case); (ii) the base case with a zone in the ground with a higher permeability; (iii) the base case with a zone of higher stiffness; (iv) the base case with a rectangular hill.

Even rate-limiting the aggregate traffic passing through the gateway router improves the fairness index two-folds over the base case with a shared FIFO queue.

The third case of investigation in this sensitivity analysis was the higher viscosity base case with a preheat period of 90 days in both wells to observe how this operation benefits the process.

On the other hand, the heat integration potential of DCU free hot streams is evaluated to enhance energy integration by 15.66% (with respect to the base case) with a simultaneous reduction of furnace duty by 37.1% and cooling water duties by 89.8%.

The squares are the fraction of reservoirs that outperform a base case with an equal flow split, F. The diamonds are the fraction of reservoirs that outperform a base case with a constant aperture within each fracture but the same flow split as observed in the simulations, (F^).

Our results in Tables 1 and 2 show that simply enforcing rate-based scheduling, even on the granularity of aggregate amount of traffic allowed through the network interface, provides upwards of two-fold improvements in JFI compared to the base case with a shared FIFO queue.

The new design reduced the heating load by 94% and reduced the cooling load by 73% compared to the base case with an annual energy savings of 53,631 kW h and a reduction in CO2 emissions of 144,267 kg of CO2.

Similar results were observed when we explored the case where a monovalent vaccine was administered (€2.82 vs. €10 for the tetravalent vaccine used in the base case) with an ICER of 1,887,000€/LYG (Additional file 1: Technical Appendix).

As the firm definition of such a case is often challenging, we pre-specified in the protocol that scenario analyses would be conducted along the base case, with an exact definition of these scenarios elaborated after the qualitative assessment of the included studies.

Three cases are simulated: a base case with no heat transfer enhancements, a case with external fins attached to the outside of the tank, and a case where an annular tank design is used.

Process plant economies of scale are typically captured through a continuous power law relating plant scale (P1) and capital cost (C1) through a scaling factor relative to a base case with plant scale P0 and capital costs C0: (2) P 1 P 0 = (C 1 C 0 ) α Econometric studies are required to determine the scale factor.