As the error bar of the cross-phase FLR frequency, we have used the half width of the cross-phase profile; this could be an overestimate, but there is no mathematically established procedure to estimate the confidence interval of the cross-phase FLR frequency.
Moreover, for bars of the aforementioned cross sections of various lengths, the influence of the STMDE is systematically quantified, while the accuracy of the results is verified by FEM solutions employing solid or shell elements.
There are smells of "crushed scuppernongs and dust" – and, in the afternoon, "bars of sunlight crossed the back yard like the bars of a bright strange jail".
These patients (N = 43 for reader 1, first reading) are reflected by the highest bar at the crossing of the three inner axes of the graph (fig 1A).
This figure shows that the B28-B38 f R curve never crosses with the B38-B37 f R curve, which is not a good sign, even though the valid ranges of the f R curves (i.e., the two solid-line segments) are overlapped by the vertical error bars of the amplitude-ratio and cross-phase methods.
That is because the sub-frame radial appliance is much heavier than that of the crossing bar, which increases the unsprung mass of the bogie.
The underlying issue, which involved the display of a cross on federal land, was an ideologically charged church-state question — but that aspect of the case had been settled by an earlier decision barring the display of the cross.
In addition, the elastic cross-bracing bar of the side-frame cross-bracing bogie and the sub-frame radial appliance of the sub-frame radial bogie are simplified as three-directional stiffness separately in the model.
The sizes of the crosses denote the error bars of the relocated hypocenters.
Although there are solutions for the axial vibration of compound bars, i.e., bars of different cross-section connected in mechanical series, this note is to illustrate another solution.
