Sentence examples for bare surface of the from inspiring English sources

To simplify the deposition procedures it is proposed to deposit the active metal on the bare surface of the carrier.

This afternoon things looked as in Japanese art, where the objects are dashed off on the bare surface of the panel or paper, with no attempt at background, or intervening atmosphere.

Current solar receivers are usually coated with a high sunlight absorptivity layer applied over the bare surface of the absorber receiver's tubes, in order to enhance their absorptivity and light-to-heat conversion.

At the Reina Sofía, you can now get quite close to the bare surface of the vast canvas (more than twenty-five feet long by more than eleven high) before a rope intervenes and, should you lean forward over it, as I did, a discreet alarm sounds.

Clamping a copper heatsink to the bare surface of the chip is no answer because the "thermal resistance" is too high ie, such a large amount of thermal energy cannot flow from the chip to the heatsink fast enough to stop temperatures soaring.Hollow "heatpipes" full of liquids with low boiling-points can cut the thermal resistance of heatsinks.

Their superior catalytic activity is found to be due to the unique, relatively "bare" surface of the PLAL-AuNPs as well as oxidized Au species induced by the strong interaction between the "barrier-free" surface of PLAL-AuNPs and surface defects (oxygen vacancies) of CeO2 NTs.

With increasing the PVP content, the probability of bare surface for accessing the substrates to the clusters surface decreases, so the minimum ratio 40 was chosen for smaller particles formation and as well as maximizing the bare surfaces of the clusters.

It is, however, suggested that Te in PbTe devices might be sublimated and dissociated at lower temperatures when bare surfaces of the devices include any defects such as scratches, cracks, and voids, which would induce the effects discussed in this report.  .

It is, however, suggested that Te in PbTe devices might be sublimated and dissociated at lower temperatures when bare surfaces of the devices include any defects such as scratches, cracks, and voids, which would induce the effects discussed in this report.

In addition, they stated it only occurred on the bare surfaces of the flippers.

The increases in the n, b and tm with increasing applied potential are attributed to the kinetic limitation of the transport of chloride ions to the bare surface of Al at the higher applied potentials.