Sentence examples for bandwidth allocated for the from inspiring English sources

Less route discovery processes means more bandwidth allocated for the data packets transmission.

The sufficient rate is defined as the ratio of the actual bandwidth allocated for the MS to its requested bandwidth.

Since the bandwidth allocated for the network is limited, there is an issue of fairness of bandwidth allocated per each VSN node.

Since the focus is on a cluster size of three, the bandwidth allocated for the edge users in cluster i is given by, W_{e}^{(i)} = leftlfloor left(frac{W - W_{c}^{(i)}}{3} right) rightrfloor (47).

For efficiency, the BS aggregates the bandwidth allocated for the connections of the same MS into a traffic burst for transmission because the connections of the same MS get the same channel condition.

Bandwidth allocated for this channel depends on how many stations replies with ACK and could not be very large because the uplink subframe itself is tightly bounded and there are a lot of other data in it.

As a consequence, the maximum bandwidth allocated for any flow cannot exceed the available bandwidth of the selected route even if the sum of the bandwidth available on the forward candidate set can meet the bandwidth requirement of the QoS request.

With the proposed scheme, the bandwidth allocated for each SLA can be automatically adjusted according to the measured traffic load and under policy control for efficient resource utilization, while SLA compliance over the network is always guaranteed.

However, use of self-backhauling usually makes backhaul as a bottleneck due to the a) limited bandwidth allocated for legacy macro RAN, b) the need to share resources with macro user equipment (UE), and c) the high-intercell interference particularly in the macro cell edge.

In the paper, we look for an admitted region of these parameters values, in which QoS requirements are met for all recipients, and then optimize the values, remaining in the admitted region, to minimize the bandwidth allocated for a given multicast stream.

Thus, for a given number of stations and PER distribution, we can find the optimal number of ACK-leaders minimizing the bandwidth allocated for a given multicast connection per frame (see (7)), while meeting a certain QoS requirement on PLR for all recipients.