bA and B indicates that the farmer has two herds with 7 30 kg pigs.
Given T ab and T ba, nodes A and B should, respectively, transmit with data rates of B ab /T ab and B ba /T ba bits-per-second (bps) to exchange the B ab and B ba bits messages, which are given by Shannon capacity formula as B a b T a b = W log 2 1 + P a t h a b 2 N 0, B b a T b a = W log 2 1 + P b t h a b 2 N 0. (2).
The minimum value constraints on T ab and T ba are due to the transmit power constraints, without which the data rates B ab /T ab and B ba /T ba will be too high to be supported even with the maximal transmit powers.
When the SEs in two directions, i.e., B ab / WT ab ) and B ba / WT ba ) are high, it is easy to see that the approximations in (26a) are accurate.
Significant difference (P < 0.03) compared with bA, B, and D; cA, B, and C; dB and C; and eB and D. Hemicellulose, like lignin, acts as a physical barrier that protects cellulose against enzymatic degradation, but this barrier can be overcome through the synergistic action of enzyme cocktails with enhanced hemicellulolytic capabilities [ 45].
"Ba ba ba," short and staccato, he explained to the musicians, "not ba-ah, ba, ba".
Finally, overall activation was more intense in rostral than in caudal areas (i.e., higher activation intensity in BAs 46 and 45 than in BA 44 and no differences between BAs 46 and 45).
It shows that the EEs of DT and OWRT do not depend on the ratio B ab /B ba, but the EE of TWRT reduces as the difference between B ab and B ba increases, and may even become lower than those of OWRT and DT. Figure 8 Impact of unequal bidirectional packet sizes.
When TTWR is large, the data rates B ab /TTWR and B ba /TTWR are low, and all transmit powers are below their maximum values.
After the B ab and B ba bits are transmitted, the system turns into idle status during T - T ab - T ba, where both nodes A and B are in idle mode.
Note that the system may not be able to transmit B ab and B ba bits within the duration T even if the maximum transmit power is used.
