The phrase "axis when using" is not complete and lacks context, but it is grammatically correct and can be used in written English.
You can use it when discussing a specific axis in relation to a particular application or tool, typically in technical or scientific contexts.
Example: "Make sure to adjust the axis when using the graphing software to accurately represent the data."
Alternatives: "coordinate when utilizing" or "dimension when applying".
Modest off-axis orientation still results in directional benefit: speech intelligibility can increase for signals up to 30° off-axis when using directional microphones (Ricketts 2000; Henry & Ricketts 2003).
Paley described the problem of axis deviation when using a ring fixator, due to imbalance between muscle forces on different sides of the bone.
The cross-polarization performance for an off-axis dual reflector telescope is shown to be equivalent to an on-axis telescope when used for a large-format focal plane array.
As expected, more clipping occurs during the hours preceding and following noon when using single axis tracking.
The authors hypothesized that listeners using directional microphones would have greater difficulty in rapidly and accurately orienting to off-axis signals than they would when using omnidirectional microphones.
When using the on-axis rounded leaf end offset correction to predict the off-axis dose, the difference between the off- and on-axis 50% dose position is within ±1.5 mm.
If severe tibial bowing was present, the tibial axis was often measured as valgus malalignment when using the anatomic alignment method, even if the knee had an acceptable range of axis deviation with the mechanical alignment method (Table 3).
When using a 6-axis vertical articulated robot, the slave arm requires 9 DOF including a gripper in order to move the tip of the forceps to any position and posture within the patient's abdominal cavity.
The design and performance improvements when using a 2-axis translation stage to adjust the sail centre-of-pressure to satellite centre-of-mass offset, will also be discussed, although for launch risk reasons this stage was not included in the final flight configuration.
When using a 6-axis vertical articulated robot for the slave arm, the control algorithm must be changed to reflect a state of being inside or outside the patient's abdominal cavity because the inverse kinematics are different between the non-trocar mode and trocar mode.
