For 3BT1 and 2HYM, the two points on the x-axis, the method displayed no predictive ability.
Those percentages are much lower, and are given along the x-axis with the method labels.
Quantitative experiment is done on a commercial washing machine with instability of the balancer, the cone shape trajectory of the tub's axis and the method of obtaining a smaller vibration angle validated.
The stress state in Region A reflects Reference mechanism A, which has a larger strike-slip component than Reference mechanism B. In order to quantitatively evaluate whether the plunge of the σ1 axis differs between the two regions, we calculated the probability density function of the difference in the plunge of the σ1 axis following the method developed by Michael (1987).
The coordinates of a point corresponds to the RMSD of closest to native conformer generated by BCL (x-axis) and the method being compared (y-axis).
While windowing method provides better OOB interference mitigation for spectrum components more distant from occupied OFDM band on the frequency axis, the CCs method has the same behavior for components closer to the OFDM nominal band as shown in [34].
However, along the time axis, the interpolation method used is the spline cubic [23].
The analysis of the anatomically preformed bone corridor of the posterior column was virtually performed using axial sections referenced to the screw axis according to the method described by Ebraheim et al. [ 6].
The different findings in this study compared to the present study can be attributed to different measurement algorithms: To achieve interindividual comparability, in the present study, defined sectors along the screw axis according to the method described by Ebraheim et al. [ 6] were used, whereas Dienstknecht et al. measured the narrowest acetabular zone along the screw axis [ 3].
For an fcc crystal in the [48] zone axis, this method uses the four nearest and two second nearest neighbours to find the strain at any lattice point in the bulk.
The overall accuracy is nearly 98% for all graphs at the end of the x-axis, indicating that the method is highly accurate with as little as 500 labeled controls.
