The phrase "avoid surface effects" is correct and usable in written English.
It can be used in contexts where one wants to emphasize the importance of looking beyond superficial aspects or outcomes in a discussion or analysis.
Example: "In our research, we must avoid surface effects to ensure that we are addressing the core issues at hand."
Alternatives: "steer clear of superficial effects" or "prevent surface-level impacts".
Periodic boundary conditions were applied to avoid surface effects.
To avoid surface effects, the signals from 20 μm below the tissue surface were used for curving fitting.
To limit the roughness increase along the ND RD plane during the experiment, which would decrease the quality of the EBSD scans, and to avoid surface effects, the two identically prepared samples were fitted into a brass sheet having a gap that corresponds to the width of the two copper samples.
Molecular spacers lifting the oligo up in solution is a well-known method to increase signal by avoiding surface effects [ 28, 29].
The surfaces of glasses were polished over 100 μm, then pre-ablation was performed to avoid surface weathering effect, and laser ablation was performed in the designed route to eliminate influence of heterogeneity.
Therefore, the specimens were not ground in the same manner as for the nitrogen sorption test so that surface effects and microcracking of the cement matrix could be avoided.
The metals are generally in the form of nanoparticle, and the weight ratios to the 2D TMO&Cs are optimized to avoid the surface overloading effect.
To avoid bulk effects, a reference surface (no coupled peptide) was continuously subtracted from the signal of the active surface.
First, the absolute upper bound for atmospheric CO2 stabilization is higher than the 450 500 ppm range recommended to avoid deleterious effects of rising surface ocean pCO2 on reef accretion [4], [41].
The image area at least five atomic planes from the nanoparticle surfaces in projection was used to calculate the precision to avoid the effect of surface atom bond length variation on the standard deviation of the measured interatomic separations.
The streamer cable was towed 20 m below the sea surface to avoid the effect of sea-wave noise by seasonal wind that was blowing during the whole survey period.
