The phrase "average value measured" is correct and usable in written English.
It can be used in contexts where you are discussing statistical data or results that involve calculating the mean of a set of measurements.
Example: "The average value measured during the experiment was significantly higher than expected."
Alternatives: "mean value obtained" or "calculated average".
The average values of the CO2/H2O at ground level of the different measurement sites (0.0195 0.0150) is consistent with an average value measured for example at the FO fumarole using different comparative methods (FTIR, Filter pack and direct sampling) of about 0.063 [22].
The power generated during operation varies between 0.1 and 1.0W by steps of 0.1 W and the resin's thermal conductivity between −80% and +100% of its average value measured by means of the Transient Plane Source method.
aThe average value measured on a 7-point Likert scale ranging from "never" (1) to "very much" (7).
Average pixel intensity value was measured in 5 random nucleoplasm regions (excluding the nucleolar regions) subtracting the average value measured in the same process within the cytoplasm.
And on the subject of humidity, even though Fig. 3 shows a change in values when surface finish material is applied and when not applied, average value measured for 1 year of outdoor exposure, Multiple-layered finishing material E shows 1.29 % and waterproof of multiple-layered finishing material E is 3.16 %.
The percentage of luminescence recorded in each well was calculated, taking as 100% the average value measured from wells that were not heat treated.
The results of gene expression analysis (microarrays and quantitative real-time PCR) as well as gas exchange and fluorescence measurements in PVYNTN-infected samples were normalized to the average values measured in mock-inoculated samples at each time point.
However, the scintillation data that forms this archive is given by the indices S4 and σϕ (in particular the latter's 60 s version, herein termed Phi60), which are only average values measured at the input of the receiver Phase Locked Loop (PLL).
During the first 3 years of operation, the system has show stable and high removal with the following average values measured from the outlet of septic tank to the outlet of the upflow filter: 97.0%-BOD7, 30%-N, 99.4%-P, and 70.8%-SS.
Values of CO2 concentrations range from 1500 to 450 ppm, with average values measured decreasing from 779 ppm at ground to 450 ppm at 130 cm of height.
