Sentence examples for average time step from inspiring English sources

Because they follow the same physical laws, the dynamics observed in DMD are equivalent to continuous potential MD at timescales longer than picoseconds with differences mainly at short timescales within the sub-picosecond range (i.e., the average time step between two consecutive interatomic collisions where a potential energy step is encountered).

Time is updated in a "combined" manner from

The average time step of the computations was 21 d for an average water residence time of 60 d [ 25]. Figure 2 shows the time series of the partial pressure of CO2 (pCO2), DIC, FCO2 and NEP obtained at a reference station close to Zeebrugge harbor (Fig. 1) that is representative of seasonal pCO2 dynamics of the Scheldt estuarine plume [ 20, 21].

However, both PA and SWR buck the trend with low network overhead and modest average time steps to resistance. Figure 4 Average number of time steps between novel attacks and individual nodes' resistance to these attacks.

The number of shared software variants for a given network topology is inversely proportional to the average time steps between a novel attack on a node and the node's resistance to the attack.

The composite record covers the last ~13.6 ka with an average time-step of ~158 years between pore ice samples since 10.5 ka cal BP; however, from 13.6 10.5 ka cal BP, the average time-step is relatively coarse (~1020 years between samples) due to low accumulation rates just prior to the peatland initiation.

While the time for a full gravitational calculation can be in the range of minutes, the average time per step is of order 50 seconds, including tree build and domain decomposition (but not including on-the-fly analysis).

The raw data consists of discrete Cartesian position data with (on average) 100 points along the octopus arm and (on average) 100 time steps.

Table 7 Processing average time for each step of the preprocessing and the total time Step Intel NUC Intel i7 Laptop Negative 5.93 4.66 Logarithmic transf.

Most RL methods optimize the discounted total reward received by an agent, while, in many domains, the natural criterion is to optimize the average reward per time step.

The iterative flow time-step at the interface is a mass average of the time step for the flow conditions on either side of the interface and the iterative time step for the kinematic condition is also based on mass-average quantities.