Sentence examples for average sensitivity for from inspiring English sources

The average sensitivity for the shear-mode FBAR devices for human IgE detection was about 1.425 × 105 cm2/g.

These ratios are normalised to average sensitivity for SN and LA for the elements Mn and Fe (SFe+Mn) (elements used in the combined internal standard).

Finally, the shear-mode FBAR device with k t 2 of 3.18% was obtained, and the average sensitivity for human IgE detection of about 1.425 × 105 cm2/g was achieved.

By changing the amount of attenuation surrounding the line source, the sensitivity can be extrapolated to zero attenuated medium for each position and the average sensitivity for each system can be calculated.

The weighted average sensitivity for RDT was 95.36%.

The sensitivity data summarized in Supporting Information Fig S2 includes 44 assays (39 point mutations and 5 deletions) and the average sensitivity for the deletions (4.69%) was very similar to the average sensitivity for all assays (4.64%).

Average sensitivities for HMDSO and a-C H coa-C Hdevicoated foundevicee areut 15 and 7.5 ppm/% RH, respectively.

The CV's show that, while both D-SPECT and A-SPECT had negative slopes, the D-SPECT slope was much steeper relative to the average sensitivity of the camera than the A-SPECT slope (average sensitivities for the D-SPECT, D530c, and A-SPECT were 35.4, 20.1, and 7.02 kilocounts per min per MBq, respectively).

The maximum average specificity was 0.59 for α-value of 0.000001, while the average sensitivities for the other α-values were the same as 0.94.

This is similar to the average sensitivity of 84% for HSIL detection by HPV assay reported in a recent meta-analysis of published studies (Arbyn et al, 2004).

This sensor shows an average sensitivity of about 11.3 mV/°C for temperature detection and 7 μm/°C for thermal expansion detection.