Sentence examples for average roughness values from inspiring English sources

The roughness profiles and average roughness values were determined using 3D profilometry.

In order to study the effect of surface pretreatments on the modified TA2 surface, the surface roughness profiles and average roughness values were carried out using optical profilometry on the measured surfaces.

For that, five different values of the slit height, 0.7, 1.0, 1.5, 1.5 and 2.0 mm, were used together with five differently finished surfaces for the channel bottom wall, possessing average roughness values of 31.4, 11.4, 4.1, 1.3 and below 1 μm, which is the sensor detection limit of the contact profilometer used for the measurements.

Different average roughness values of different areas for each sample were caused by ions with wide energy spectrum emitted from the focus region.

Also, the root mean square (RMS) roughness and the average roughness values obtained from AFM measurements are shown in Table 3.

The rendered images were imported into Adobe Premier for post-production, where additional information was added, such as the average roughness values (Ra) and the magnification values.

The mean average roughness value (Ra) with addition of surfactant is 1.796 µm.

Average roughness value (Ra), measured on a surface profilometer: Talysurf PGI-120, indicated the response.

The specimens of nyatoh sanded with 80-grit sand paper resulted in the highest average roughness value of 14.75 μm.

Having fiber layers on the surface of the panels resulted in smooth surface to comparable to that of typical medium density fiberboard with an average roughness value of 6.42 μm.

EN deposits with addition of surfactant SDS and CTAB at a concentration of 0.6 g/l produce a smooth surface and the average roughness value (Ra) is 1.715 µm for SDS and 1.607 µm for CTAB which is less than the Ra value of EN deposit without surfactant addition (1.885 µm).