Sentence examples for average rod diameter from inspiring English sources
The average rod diameter is ~50 nm.
The average rod diameter and length, as determined by TEM were 4 and 20 nm (aspect ratio 5), respectively.
Moreover, the NWs on 6- and 8-nm-thick seed layers have the best alignment, with an average rod diameter of 100 nm (Figure3c,d).
Comparing the above two types of ZnO nanorods, it is obviously that the nanorod arrays grown on the ZnO film prepared by PLD have better vertical orientation and much smaller average rod diameter than those on the ZnO film prepared by RF sputtering.
It can be seen that the average rod diameter increases from approximately 75 nm for undoped nanorods (sample S1) to approximately 210 nm when 1 at.% Cu is added from Cu(CH3COO 2 (sample S2),while when 2 at.% (sample S3) is added from the same precursor, the nanorods aggregated and the structure becomes compact.
Average TiSi2 rod diameter was 2.5 μm with 99% of the population falling in the 2 3 μm range.
The rod diameter, rod length and rod pitch were 8.0 mm, 1500 mm and 1.14, respectively.
The contrast recovery increased with the rod diameter.
The rod diameter was identical to that reported for natural chlorosomal rods of Cfl.
This perturbation effect decreases with the rod diameter.
Therefore, it is important to control the rod diameter appropriately to obtain high LEE.
