Sentence examples for average reaction yield from inspiring English sources

The utilization of 482 mg of silver acetate precursor enabled the production of 296.7 mg of pure Ag MNPs giving an average reaction yield of 95.15 ± 5%% that was calculated with five syntheses.

The electrophoretic migration of H+ ions in the second reaction system prevents local over-acidification, i.e. the averaged reaction yield is higher compared to the system with no electric field applied.

Reaction yields were calculated for each sample and normalized to the average positive control reaction yield.

Full-factorial 23 central composite design and response surface methodology (RS M were applied to evaluate the effects of molar ratio GTMAC/Ch, reaction time and temperature on the reaction yield, average degree of quaternization (¯¯¯¯¯¯DQ) and intrinsic viscosity of QCh.

A design of experiment was used to quantify the effects of pH, reaction time, and hydrogen peroxide concentration on the reaction yield, average molar mass, and free monosaccharides generated.

Using reaction yield, instead of raw peak area, for analysis combined with averaging three injections per sample mitigates this effect.

In this experiment, average reaction times were 279.1 ms. Subtracting the lower bound of high gamma activity from the reaction time yields 79.1 ms required for both the selection of an action and its execution.

The reaction yield is strongly pH-dependent.

The percentage composition of TnBPO after 15 min was calculated to be 30% on average, which is consistent with the reaction yields of CdSe QDs using TnBPSe16.

A typical reaction yielded 500 mg of functionally modified silica NPs with an average diameter below 100 nm.

15.3 Reaction Yields.