The phrase "average orientation of the" is correct and usable in written English.
It can be used in contexts where you are discussing the typical or mean direction or position of something, often in scientific or technical writing.
Example: "The average orientation of the molecules in the sample was determined using advanced imaging techniques."
Alternatives: "mean alignment of the" or "typical direction of the".
We study the settling velocity and the average orientation of the ellipsoids as a function of volume fraction.
Under certain conditions, the average orientation of the helical axis was inclined relative to the plane of the substrate, approaching perpendicular in some cases.
The average orientation of the ellipsoids also shows a similar local maximum and we observe that this local maximum disappears as the Reynolds number is increased.
Tensile modulus of the extruded tapes along the flow direction was measured and was found to correlate well with the average orientation of the clay tactoids.
An idealized polycrystalline interconnect which consists of grains separated by parallel grain boundaries aligned normal to the average orientation of the surface is considered.
The average orientation of the initial shish is relatively high while the orientation of parent lamellae decreases with their lateral growth.
The angle between the normal direction of the substrate surface and the average orientation of growth of the rods is about 66°. Figure 1 Top view and cross-section SEM images.
If deformed grains (type II) had multiple γ-fiber components as the average orientation of a UG, the density of the nuclei steadily increased as the elapsed time of in situ annealing increased.
The H quadrupolar splitting magnitudes |Δνq| from the alanine CD3 (or C-D) groups serve to define a preferred tilted, dynamically averaged, orientation of the entire helix with respect to the bilayer normal in an applied magnetic field.
If deformed grains (type III) had texture components which could not be assigned to either γ-fiber or α-fiber components as the average orientation of a UG, the number of the recrystallized grains was maximized, but the recrystallization kinetics based on a normalized number of recrystallized grains was similar to that of type II.
We show the spatial distribution of the average orientation of ϕ and the average normalized time delay at each station in Fig. 7. Here, we consider that the anisotropy is the stress induced anisotropy when the angular difference between the average ϕ and the principal compressional axis of the strain rate is within 30°.
