Sentence examples for average lateral dimension from inspiring English sources

The resulting single-layered nrGO-PEG sheets were approximately 50 nm in average lateral dimension and exhibited great biocompatibility and approximately 7.6-fold increment in NIR absorption.

The treatment of SWCNTs has resulted in two kinds of GQDs (i.e. GQD1 and GQD2), both of which are monodisperse and single-layered nanosheets with an average lateral dimension of 8 nm and an average height of 0.5 nm.

After adsorption of dodecin, the surface was covered by densely packed round features with an average lateral dimension of about (12.5±4) nm.

The hill-shaped features with average lateral dimensions 50 100 nm can be observed on the surface of samples.

Two controlled sizes of graphene sheets (100 nm vs. 45 μm average lateral dimensions) were prepared to study two-electrode system performance.

The cell viability test showed significant cell destructions by 1.0 μg/mL rGONPs with average lateral dimensions (ALDs) of 11±4 nm, while the rGO sheets with ALDs of 3.8±0.4 μm could exhibit a significant cytotoxic effect only at highconcentration of 100 μg/mL after 1 h exposure time.

Akhavan et al. [69] demonstrated that size and concentration are dependent on the cytotoxicity and genotoxicity of graphene oxide sheets and nanoplatelets in the hMSCs and found that the reduced graphene oxide nanoplatelets with average lateral dimensions of 11 nm exhibited a strong potential in the destruction of the cells.

In a typical synthesis, the injection of the Se-precursor into the hot solution of Cu-precursor in 1-dodecanethiol (DDT /oleylamine (OlAm) mixture yields NPLs with average lateral dimensions of 17.6 ± 4.6 nm and thickness of 4 ± 0.2 nm after 4 min of the reaction at 220 °C.

In addition to the relative proportion of cellulose crystalline allomorphs and amorphous cellulose at accessible and inaccessible fibril surfaces, the C4-carbon region in a C CP/MAS spectrum of isolated cellulose along with a simple geometric cellulose fibril model [ 44, 45] can estimate the average lateral fibril dimension (LFD) and lateral fibril aggregate dimension (LFAD) of cellulose.

The SNR was computed as SNR = (S- μ noise)/ σ noise, where S was the measured signal peak amplitude at the position of the mirror surface averaged across the full lateral dimension of the acquired Doppler image, and μ noise and σ noise were the mean and standard deviation of the noise floor measured within the region around the signal peak while the sample beam was blocked, respectively [ 13].

The average nanorod length was approximately 520 nm, and the lateral dimension became larger than that of GaOOH nanorods grown at −1.8 V.