Sentence examples for average intercept length from inspiring English sources

With decreasing strain rate, the volume fraction of {0 0 1}〈1 1 0〉 increases with the increase in the average intercept length of crystal grains along the transverse direction at both 1093 K and 1173 K, which implies the occurrence of dynamic grain growth during the deformation.

Mean intercept length (MIL) method has been designed for the analysis of binary images.

The degree of anisotropy (DA) was calculated as the maximum to minimum mean intercept length ratio.

Furthermore, mean intercept lengths and mean numbers of particles are measured and discussed.

Differing mean intercept lengths for different 3D angles indicate an anisotropic spatial organisation [ 55].

The mean linear intercept length depends strongly on the spread in spatial grain size.

The most popular parameter for assessment of emphysematous alterations, mean linear intercept length, has severe limitations.

Hence, there is no general proportionality between the mean linear intercept length and the spatial grain size.

In the typical research setting where one does not know subject specific intercepts, however, the average intercept value (given in the equations above) would be used.

Theoretically, if one knew which subject wore the AM and their subject specific intercept value, one could do better than by using the average intercept value.

The residual υ0 i is the random intercept, arising from a normal distribution and describing the deviation of hospital i from the average intercept.