The phrase "average intensity value" is correct and usable in written English.
It can be used in contexts such as data analysis, image processing, or any field where measurements of intensity are relevant.
Example: "The average intensity value of the pixels in the image was calculated to assess the overall brightness."
Alternatives: "mean intensity level" or "typical intensity measurement".
The average intensity value of the darkest sub-region of each member serves as its fitness value.
The objective comparison of image enhancement performance is performed after modifying the average intensity value of each resulting image to the average value of Fig. 5 a. PSNR and SSIM values are summarized in Table 1.
where ∗ is the 2D convolution operator and G ε is a Gaussian smoothing kernel with variance ε, i.e. μ is the weighted average intensity value in the disk of radius ε centred at x (B x,ε)).
The size of the local region is (2p + 1) × (2q + 1); we take the average intensity value of this local area instead of the intensity of a single boundary point.
Mean : the average intensity value of the variable: mu =frac{{displaystyle {sum}_{i=1}^M}{v}_i}{M}. Median: the middle value of the variable when the data is aligned either in increasing or decreasing order.
Lowering the average intensity value of the image to better visualize clipped bright areas is then not effective, due to a very high intensity of these areas which can be several times higher that the available dynamic range of the imaging sensor.
One of the examples is the Multi-scale Block LBP (MB-LBP [24], MB-LBP [24]e average intensity values of neighboring rectangular blocks are compared rather than single pixels.
However, the good agreement of our reconstructed average intensity values lends additional support to our method and also demonstrates that two different ways to measure the same intensity give comparable results.
After analysis, the average intensity values from each TTP deposit were calculated and a linear regression concentration curve was constructed for the MS and MS/MS experiment, respectively (Fig. 2).
The GSA-Cell line application provides an interface for exploring mRNA expression levels of gene sets across 51 previously reported breast cancer cell lines [23], reporting both relative gene expression levels across the cell line panel, as well as summarized average intensity values.
