The phrase "average inclination" is correct and usable in written English.
It can be used in contexts where you are discussing a general tendency or trend in data, behavior, or attitudes.
Example: "The average inclination of the participants was towards a more conservative viewpoint on the issue."
Alternatives: "mean tendency" or "typical inclination".
It has been suggested that Iapetus's 15° average inclination is a relic of the tilt of the long-vanished gaseous disk from which Saturn's major regular moons formed.
Let the changes in inclination angle and azimuth angle be ΔαAC and ΔβAC, and the average inclination angle of points A and C be α0.
The average distance between seams A3 and B4 is 80 m and the average inclination angle of the seams is 13°.
The average inclination in zenith as seen from the OGS is 28.3° (unlike the orbital pass shown in Fig. 9 where φ goes down to 0°).
Thus, the coefficient of friction beneath the moving material is only approximately 0.12, given an average inclination of 15° in the major landslide profile, although the inclination exhibits gradual variations in the range of 10° to 20° (Figure 1).
Because inclinations of dust particles are conserved during the orbital evolution under the P-R effect, ī is identical to the average inclination of EKBOs, namely, ī ∼ 0.1 (e.g., Noll et al., 2008).
The average inclinations of individual cores were close to those of the geocentric axial dipole (GAD) field at the site latitudes.
The results of sensitivity analyses show that the average inclinations of the reverse fault ruptures increase by increasing both fault dip angle and soil ductility, due to the variations of the maximum principle strain directions and dilation angles along the fault ruptures.
The dip slope has an average incline of approximately 15°, and the inclination varies from 10° to 20°.
The mean inclination angle was 42° (24 63).
After 20 nm Si growth, however, the stripe morphology has changed to a shallow "V -shaped form with an aV -shapeddewall inclination close to 9° as revealed by the corresponding STM image and surform orientation map showithn Fig. 2b.
