Sentence examples similar to average height of surface irregularities from inspiring English sources

The non-dimensional parameters Λ (surface roughness parameter) and γ (surface pattern parameter) have been defined to represent the magnitude of height distribution of surface irregularities and their orientation, respectively.

The surface height is normalized to the maximum height, where average height of the surface is 0. The peaks are shown by the red regions while the troughs are shown as blue.

The amplitude scintillations come from irregularities having a scale size of the first Fresnel zone, which depends on the signal wavelength and average height of the irregularity layer (z).

The average height of the smooth Ag surface was approximately 6 nm, while for the rough surface, it was measured at over 100 ± 2.62 nm on average.

STM images of the TMA-exposed surface reveal two-dimensional (2D) islands on the surface with an average height of approximately 0.19 nm (a pixel height histogram was used for island height estimation and is shown in Supporting Information Figure S3).

Both of the textured films comprised oval surface features with the average height of 10 μm, the diameter of 10 μm and the separation length of 20 μm.

For parallel bound molecules, volume exclusion with the surface would result in an average height of about 15 nm above actin.

These subunits appeared longer and curlier than the vimentin ones with an average height of 0.62±0.07 nm (n = 67) and an average area on the surface of 909 nm2.

The subunits appeared mainly as dots with an average height of 0.66±0.07 nm (n = 50) and an average area on the surface of 587 nm2 that is equivalent to a disk of diameter 26 nm (Figure 8A, arrowheads).

The vimentin subunits had an average height of 0.31±0.07 nm (n = 58) and covered an average area on the surface of 570 nm2.

The average height of the current team is five six.