The phrase "average differences are" is correct and usable in written English.
It can be used when discussing statistical analysis or comparisons between groups, particularly in research or academic contexts.
Example: "In our study, we found that the average differences are significant between the control and experimental groups."
Alternatives: "mean differences are" or "typical differences are".
Results are compared to those obtained with a generalized beam theory (GBT) software for 'pure' distortional mode and it is shown that, within the range of typical geometries used in industry, average differences are approximately 1.062 ± 0.073 and 0.998 ± 0.001 for Models 1 and 2, respectively.
It appears, then, that the Aggressive criteria will produce lower residual astigmatism in the population of eyes on average but these average differences are nominal.
Average differences are estimates, via unweighted ordinary least squares, of the slope of a linear regression of cost on multimorbidity count, where body system counts of seven and greater were coded as seven.
However, knowledge of average differences is not sufficient to understand participation decision across a sample of farmers, since they do not account for the effects of other characteristics including factors influencing participation.
The largest average differences were between 1.25 mm and 5 mm slice intervals, while the smallest average differences were between 1.25 mm and 2.5 mm for all measurements.
The average differences being –1.53 fixations, 1.24 ms fixation duration and 0.01° saccade size.
As expected, the average differences were very small as compared to values obtained from log2 PM/MMi) across 25 probe positions.
All average differences were in favor of the CID score and in accordance with what we measured for the standard peptides.
Significant average differences were found between traditional and non-traditional organizations in organizational size, budgetary priority, and partnership-value in- and out-degree scores, and tie homophily.
For all measurements, the largest biases were seen between 1.25 mm and 5 mm, whereas the smallest average differences were seen between 1.25 mm and 2.5 mm (except for the VOL, a slightly smaller average difference was found between 2.5 mm and 5 mm).
