The phrase "average density in" is correct and usable in written English.
It can be used when discussing the typical mass per unit volume of a substance within a specific context or location.
Example: "The average density in the region was found to be significantly higher than in other areas."
Alternatives: "mean density within" or "typical density in".
Thus, the average density in the wide layer considered here remains close to the liquid bulk density.
From the comparison with the simulation results, the average density in this region can be derived to 1.92 g cm−3.
Based on this comparison with the simulation results, the average density in this region is derived to be 1.82 g cm−3.
From the plot of average density in Fig. 7b, we can observe that the density is gradually decreased with the increased dwelling time.
The average density in water of phytoplankton was 29,661 (11,359–48,857) individuals/L and the average density of zooplankton was 3530 (1002 7651) individuals/L.
Since the average density in a conduit depends on the ratio of ascending and descending magma, the density deduced by muon radiography must be in between the ascending and descending curves.
The RSMDF was produced at different thicknesses (7 mm, 9 mm and 16 mm) and average densities in the range of 728 941 kg/m3.
The four inner, terrestrial planets Mercury, Venus, Earth, and Mars along with the Moon have average densities in the range of 3.9 5.5 grams per cubic cm, setting them apart from the four outer, giant planets Jupiter, Saturn, Uranus, and Neptune whose densities are all close to 1 gram per cubic cm, the density of water.
Detailed morphological analyses were conducted and a clear nonlinear decreasing trend was observed between implant average micromotion and both the metaphyseal canal flare indices and average densities in Gruen zones.
The ratio is determined by calculating the average densities in two regions of 3 km thickness centered around 97 and 87 km, representing the sporadic and main layers.
Contrary to this, variations between estimated average densities in a single well and actual data using the local calibrations is not up to 0.08 g/cc for the shales (see well GB) and sands (see well AS).
