Sentence examples for average correction factor from inspiring English sources

Open image in new window Fig. 9 Comparison of absolute values of error using average correction factor and without correction.

The largest sensor location correction factor was obtained at the measuring location A2, and about 50% of the correction factors were above the average correction factor of 1.09.

Parameter values, such as a stable production duration or gradual reduction rate, under the same production profile type, also affect the time value correction factor; however, these effects can be ignored during the selection phase under the premise of reasonable type differentiation; therefore, an average correction factor is used in the calculations.

In the stratified populations with moderate and high stratification levels, the average correction factor λ estimated by GC became very large (>7.5).

The effects of each parameter on the performance of the four analytical methods are detailed in the following: Table 2 summarizes the average correction factor λ estimated by GC approach under various stratification levels.

Average correction factors were then derived for measured and theoretical X-ray spectra at 30 50 kVp.

Another way to investigate whether the application of overall sensor location correction yields any improvements in the determination of the average air velocity is to compare the error using the average sensor correction factor and the error caused by reading the sensor directly as the average air velocity without correction.

The influence of using an average shear correction factor is evaluated through numerical experiments.

average general correction factor (accounting for bark, forest residues and other corrections, suggested by [ 28] and by [ 23]. average general correction factor suggested by NIR 2013 [ 28].

average general correction factor (accounting for bark and other corrections) applied to original FAOSTAT data from 2000 to 2012; the CF varied year by year, assuming that the figures reported by the Submission for FMRL represent the correct estimates (Joachim Rock, pers. com).

The effects of material properties and elastic foundation variation, the layering fineness, the average shear force correction factor and the axial forces have been evaluated and discussed.