The phrase "available adsorption" is correct and usable in written English.
It can be used in contexts related to chemistry, environmental science, or materials science, where one discusses the capacity of a material to adsorb substances.
Example: "The study focused on the available adsorption of pollutants by activated carbon in water treatment processes."
Alternatives: "accessible adsorption" or "open adsorption".
The reduced column capacity resulted from the decrease in available adsorption sites and resulting repulsion (i.e., blocking) of incoming antibiotics from those previously adsorbed.
The available adsorption working pairs applied to adsorption refrigeration system, which utilize activated carbon as adsorbent, are mainly activated carbon methanol, activated carbon ammonia, and composite adsorbent ammonia.
In fact, the available adsorption volume is as important as the isosteric heat of adsorption for hydrogen storage in nanoporous carbons.
This indicates that Fe- and Al-oxides and other available adsorption sites on the mineral surfaces are coated by organic matter and are activated only after removal of organic matter.
Then, a slower adsorption would follow as the available adsorption site gradually decreases.
These results indicate that the removal efficiency is directly related to the number of available adsorption sites.
In this case, other parameters need to be considered especially the adsorbent dosage which provides the information on the available vacant adsorption sites for adsorption of As III) at higher concentrations.
At lower initial concentrations of Pb2+, an adequate number of active sites are available for adsorption, leading to a higher adsorption capacity.
The 1/β value reflects the number of sites available for adsorption whereas the value of 1/β ln indicates the adsorption quantity when ln t equal to zero.
The 1/β value signifies the number of sites available for adsorption and the value of (1/β) ln shows the adsorption quantity when ln t equal to zero.
The 1/β value reflects the number of sites available for adsorption whereas the value of 1/β ln indicates the adsorption quantity when ln(t) equals to zero (Ayanda et al. 2013; Ahmad et al. 2014b).
