Sentence examples for attaining a stable from inspiring English sources

From extensive simulations (single- and multi-hop networks) and comparisons with several existing MAC protocols, including MACA-U, MACA-UPT, BiC-MAC, Slotted-FAMA, DACAP, unslotted Aloha, we show that ROPA significantly increases channel utilization and offers performance gains in throughput and delay while attaining a stable saturation throughput.

Because previous studies on the factors influencing relapse after Herbst treatment[22, 23] emphasized the importance of attaining a stable occlusion at the end of Herbst appliance therapy, the treatment objective of the present sample was to establish Class I relationship during the active phase of treatment rather than to 'overtreat' the occlusion in to a 'super Class I' relationship.

Immediately after attaining a stable whole-cell recording, the resting membrane potential was recorded in current-clamp mode.

Figure  2C shows shift in orientation of the ligand within the catalytic cleft of TACE after attaining a stable state.

This may be due to the technique of isolation used (ring cloning) or may be due to chemically-treated cells requiring long periods of culturing before attaining a stable phenotype.

The methodology for attaining a stable mononuclear Zn II) site with the desired coordination geometry is now well-established, although there is minimal success at incorporating second-sphere interactions.

If this landscape remains undisturbed for a long enough time, the evolving biological community can once again attain a stable ecological structure.

At the 15- and 18-month follow-up, respectively, both patients attained a stable, solid fusion with maintenance of the medial longitudinal architecture.

Model order is determined using Akaike information criterion and the model parameters are estimated through the application of partial least squares to attain a stable solution.

The PAN ionomer based polymer electrolytes showed good interfacial resistance stability, while the PAN based polymer electrolytes could not attain a stable interface with the lithium electrode.

It is shown that more than 40 measurements of Sa may be needed to attain a stable value, but that choice of an appropriate sampling strategy may reduce this requirement considerably.