Sentence examples for attained by applying from inspiring English sources

Densification of stacking particles was attained by applying bi-modal size distribution to the feedstock Ti powder.

This state can be attained by applying recycling hydraulic modes and special devices to maintain constant pH, or pH and concentration of the feed solution.

Maximum amount of Mo in the films was attained by applying deposition potentials in the − 1200 mV to − 1300 mV range.

Macro- and micro-structural studies showed that sound joints, which were free of voids, cracks or un-bonded areas, could be attained by applying w=1200 rpm and v=50 mm/min, while locating the nanocomposite at retreating side.

The reduced volume of permeable voids and less continuous capillaries, attained by applying the proper curing regime, leads to an increased electrical resistivity and compressive strength of the low-calcium fly ash-based GPCs.

This is attained by applying appropriate variation of the W/L ratios of the bias cascode current sources via the employment of additional programmable switches such that their saturation voltages remain relatively constant, something which in turn enables the output currents range to be as wide as it is required.

This approach is based on a commonly applied concept that standards of excellence attained by top performers should be used as benchmarks of quality in the health care sector [ 45].

The highest warrior rank, seii taishōgun ("barbarian-quelling generalissimo"), was first attained by Sakanoue Tamuramaro, and the title (abbreviated as shogun) was later applied to all shogunate leaders.

This can be attained by the hydrostatic head of the drilling fluid or the combination of applied surface backpressure and the hydrostatic head of the drilling fluid (managed pressure drilling MPD scenario).

There were no new concepts reported or codes applied after the 7th interview transcript, which suggests that saturation was attained by the eighth interview.

High levels of both smoothness and brightness of AISI-304 stainless steel surfaces can be attained by using electropolishing technique, where the sample was fixed as anode and a suitable current was applied into electrolytic cell containing H3PO4.