The phrase "attainable pressure" is correct and usable in written English.
It can be used in contexts discussing achievable levels of pressure in various fields, such as science, engineering, or psychology.
Example: "In order to maintain optimal performance, it is essential to find a balance between challenge and attainable pressure."
Alternatives: "achievable pressure" or "realistic pressure".
Due to the massive support and lateral support of the anvils, attainable pressure in MAAs far exceeds the compressive strength of the anvil material.
The available measuring devices in the ultra-high and extreme high vacuum range with their limitations are presented on the basis of the ultimate attainable pressure.
The minimum attainable pressure near the producer is about 43 MPa.
In addition, the use of large samples is advantageous for precise measurement of sample volume, although the maximum attainable pressure would be somewhat limited.
By considering the attainable pressure in the current vacuum system and actual background strain, the average pressure in the pipes is designed to remain below 0.01 Pa, as listed in Table 1, and the measured pressure is used to correct the strain to attain actual strain sensitivity (Delta varepsilon) ~ 10−12.
The demand for higher combustion efficiency and performance is attainable through pressure gain combustion.
A possible provision of a regenerator is examined with an attainable effectiveness, least pressure drop and small weight for a modified veteran turboshaft helicopter engine.
All data was recorded at the lowest pressure attainable under normal operating conditions of our setup (low 10 −8 Torr).
Ultimate pressures attainable are limited by leakage between the high- and low-pressure sides of the pump (due mainly to carryover of gases and vapours dissolved in the sealing oil that flash off when exposed to the low inlet pressure) and decomposition of the oil exposed to hot spots generated by friction.
This appears to be the maximum pressure level attainable by using WC anvils.
The results show that a current of 13.9 μA per nozzle was attainable for a spray pressure of 400 kPa with a liquid flow rate of 0.45 l min−1 and droplet spectrum with a 115 μm volume medium diameter (VMD).
