Sentence examples for attaching sample from inspiring English sources

Transect A surface water was collected at 1-h intervals without entering the stream, by attaching sample bottles to a pole sampler and positioning them at mid-depth in the center of flow until full.

16 Fibroblast attachment was recorded after 4 d, to allow the cells time to attach, sample the surface and proliferate (given appropriate surface conditions).

-ends- Visuals attached: Sample Observer front page and examples of poster advertisements.

Amount of MWCNTs Chemical route followed Dispersion before functionalization Functional groups attached Sample code 1 40 mg Double-step functionalization No -COOH -SO3H FPCNT01 2 50 mg Double-step functionalization Yes -COOH - SO3H DFCNT03 3 50 mg Single-step functionalization Yes -COOH FCNT03 4 20 mg Single-step functionalization No -COOH -PO3H2 PhCNT01.

The transversal cross section of the PA cell with the attached sample and reservoir for liquids is depicted in Fig. 4. The PA cell and the sample reservoir are constructed out of a copper block (4 x 25 x 35 mm).

For scanning electron microscopy, the sample was allowed to settle on the surface of a poly- l-lysine-coated glass cover slip for 30 min, and the attached sample was then fixed with 0.1% glutaraldehyde in 0.1 M phosphate buffer (pH 7.4) for 10 min, washed three times with 0.1 M phosphate buffer, and post-fixed with 1% osmium tetroxide in the same buffer for 10 min.

Attach sample work with CV.

wanted to attach samples of cough drops to match books but didn't want their samples on the back of anything.

"Ninety percent of our production is exported," said Ian McCormick, international managing director for Equalizer, standing beside a yellow mock-up pipeline to which were attached samples of his company's stainless steel clamps.

This report studied the flexural strength, relative dynamic elastic modulus and sulfate content under sulfate attack incorporating with dynamic flexural loading (stress level = 20%, 40 % and 60), and also analyzed the microstructure and atom ratio of attached samples via SEM and EDS.

If crypts were still attached, samples were gently shaken for an additional 30 seconds to 2 minutes.