Sentence examples for attached bead from inspiring English sources
We found that the in-plane orientation of a single nanomembrane can be controlled about a single point of rotation, by harnessing the deleterious scattering force that otherwise precludes direct manipulation of membranes without an attached bead.
Typically, a small region of interest surrounding a single tracked bead is captured and we record displacements of the attached bead before and after treatment with cyto-D.
When the attached bead was displaced, the force applied to the focal adhesions transiently rose, and then declined in less than a few seconds, indicating a tension decline in the stress fibers, probably due to a partial destruction of the linkage among the actin fibers within the stress fiber, which would decrease its elastic modulus.
The fraction of moving beads was measured by resting beads on the flagellar surface for 1 min. Viscous drag constant between the bead and the flagellar membrane was measured by oscillating a flagellar surface attached bead ±500 nm along the length of flagellum in a square wave pattern at 0.2 Hz.
A magnetic screen collects cells with attached beads.
Also, they attached beads or ornaments made by the use of 3DP to make an effect of looking like embroidery.
Bundles are polymerized from the surface of mDia1-coated latex beads, and deformed by manipulating both ends through attached beads held by optical tweezers, allowing us to record the applied force.
(A ) I. A cohort of cells with cell-wall attached beads is maintained in the magnetized column (magnet 1) and harvested at set time points (column fraction) when also a fraction with mainly daughter cells is collected (column effluent, mix 3).
To attach beads to the two ends of an actin filament, the surface of polystyrene latex beads (0.945 µm in diameter) was coated with α-actinin as previously described [19].
We tried to attach beads to the detached cells, but without success.
This HA-coated ingrowth surface does not require heat treatment to attach beads, and therefore preserves the carbide structure.
