Then, biocitro and lemon extract (0 80 ppm) were combined with two different thermal treatments (at 70 and 80 °C for 3 6 min) through a fractional factorial design and finally a treatment at 80 °C for 6 min was combined with either biocitro (80 ppm) or lemon extract (80 ppm) and tested in apple juice.
Thermal properties of five screed specimens were evaluated by four different thermal analysis methods.
In this work, the endurance behavior of a ball grid array package is determined at two different temperature cycle conditions: a thermal cycle test and a thermal shock test.
Once finished with measuring various thermal parameters of the system experimentally at two different flowrates, overall heat transfer coefficient and thermal efficiency of the system are calculated.
Additionally, thermal cycling at two different temperature levels was achieved by controlling the power of the local heater.
Thermal degradation studies were performed at two different temperatures: 40°C in water bath and 105°C in oven (dry heat thermolysis).
The changes in the mechanical and thermal properties with absorbed dose at two different dose rates were measured.
Metabolic rate in ectotherms increases with increasing temperature, an effect known as the Q10, which can be characterized by the slope of the thermal reaction norm of metabolic rate for each genotype measured at two different temperatures.
For example, the peaks of the distributions comparing datasets at two different temperatures (RT versus cryogenic) with the same ligand state are offset from zero, which shows that there is thermal contraction of the protein.
Thermal conductivity (k) measurements were performed by ThermTest Inc. (Ref. [15]), and samples S4 and S6 were measured at two different densities each (Table 1).
