Sentence examples for at the maximum depth from inspiring English sources

The "lift and deepen" scheme would see old remains being dug up, placed in a small container and re-buried at the maximum depth to allow more burials in the same plot.

The local stress intensity factor solutions at the critical locations or at the maximum depths of the kinked cracks are obtained.

Measurements taken from this perspective indicate that the radius of the colony is larger than its height, with the width at 35 μm but the maximum depth at 10 μm.

The subduction earthquakes terminate at ∼17.5°N, where the maximum depth of the seismic plane is 60 km.

Equation 5 states that the harmonic-averaged thermal conductivity at every lateral grid position ((i,j)) is a function of thermal conductivity values at all cells down to the maximum depth at that location as well as their thicknesses.

The strait is about 8 miles (13 km) wide at its narrowest point, and the maximum depth on its sill (submarine ridge between basins) is only a little more than 1,000 feet (300 metres).

If the gradient is constant over the depth range, then v can be further simplified as v ∝ p(s) − p(g), where p(s) and p(g) denote the pore pressures at the 222Rn source depth (the maximum depth from which 222Rn can reach the detector) and the ground surface, respectively; p(g) is almost constant (=1 atm) despite small fluctuations with weather conditions, and p(s) is variable.

The optimal depth of any suspended culture of algae cells should be equal to the maximum depth at which a sufficient amount of solar light can penetrate.

The maximum depth at which correlated CRS and CM data can be acquired is largely dependent on the optical properties of the sample, which can vary substantially.

In order to understand what limits the maximum depth at which CGWS can be performed, we need a better understanding of the selection of photons by the CG as a function of the depth in the tissue.

Identifying the upper limit of biomass density and the maximum depth at which algae cells are still effectively illuminated depending on the specific design of the reactor (different thicknesses of the water layer) has been an interesting task for our research team.