The phrase "at minimum load" is correct and usable in written English.
It can be used in contexts related to engineering, power systems, or any situation where load levels are being discussed, indicating the lowest operational level.
Example: "The generator operates efficiently at minimum load, ensuring optimal fuel consumption."
Alternatives: "at lowest capacity" or "under minimal load conditions".
By adopting adaptive biasing (ADB) technique, the loop bandwidth is extended proportionally to the output load while maintaining high current efficiency at minimum load.
Different numerical parameters can be considered to quantify the opening level, namely one based on the analysis of contact stresses at minimum load.
For photolithography, the head was brought into hard-contact (at minimum load) and the exposure dose (forward current across the UV LED and exposure duration) was varied for each tested resist to determine the optimum curing conditions.
Deflections were computed from the motion tracking data throughout the cyclic tests at minimum load to identify plastic construct deformation.
The magnitude of the gap displacement after 7500 cycles was at a maximum 0.09 mm for the Frame-group and 0.18 mm for the LCP-group (measured at minimum load).
For 40%and20%0% prestressed beams, there is no improvement in fatigue performance for load ranges above 20%and13%3% of the ultimate capacity of the beams a level at which calculations showed that the remaining prestress did not close cracks at the minimum load in the fatigue load cycle.
Post-layout simulation results show that the LDO occupies an active area of 0.069 mm2, consuming only a quiescent current of 4.45 µA at a minimum load of 100 µA.
When compared on the basis of load range versus cycles to failure, the data for the three beam types fell onto a single curve at load levels where the remaining prestress after fatigue creep relaxation no longer closed the crack at the minimum load.
Modifications to coal plant operations will also affect the emission rates of other pollutants, especially since selective catalytic reduction systems must be operated at a minimum load [6], but this is not discussed in the paper.
The mechanical behaviour of this type of material involves time consuming and costly tests under cyclic load with superimposed hold time at maximum or minimum load level, representative of typical service loading conditions.
Fig. 8. Contours of the initial solar minimum load at 250 km altitude (a) is the oxygen ion load, (b) is the molecular oxygen ion load.
