The phrase "at higher total" is not correct in standard written English.
It may be intended to refer to a total that is greater than another total, but it lacks clarity and proper grammatical structure.
Example: "The expenses were calculated at a higher total than expected."
Alternatives: "at a greater total" or "at an increased total".
AC2K-200 was further tested at higher total pressures, for 0–5000 mbar pressure range, at 25 °C.
The observed treatment efficiency of the new design was comparable to that of conventional digesters operating at higher total solids concentrations (>4%).
The total porosity is important in cresting problems such that at higher total porosity, the greater the tendency for cresting to occur and vice versa.
At higher total pressure and lower temperature, the SiC-SiO2 nanocomposite film was obtained, with SiC grains about 10 nm in diameter distributed in amorphous SiO2.
Surface morphology of nanowires become rough as clustered surface with higher diameter mainly in range of ~300 540 nm (inset of Fig. 4b) at higher total gas flow rate is keeping gas mixer ratio constant.
The surface morphology is strongly influenced by the total pressure and the anatase TiO2 films with a more open surface, a higher surface roughness and a larger surface area are formed at higher total pressures.
A γ-Al Cr O N phase is formed at high total gas pressures and low Cr/(Al + Cr) ratios.
Devices fabricated using an optimized PAO process exhibited GS lasing at high total output power of 272.6 mW at ∼1.3 μm under CW operation.
It should be noted that the resolution degradation at high total dose-rates cannot boundlessly be mitigated by this acquisition strategy.
At high total pressure even sputtering of pure TiOx barriers is unlike non-reactive sputtering of TiOx not sufficient to prevent the strong surface segregation effect.
Except the recently published studies (Massé and Saady 2015a, c; Saady and Massé 2015), no information has been published on the psychrophilic anaerobic digestion of CFWS at high total solids (>20 %) and high OLR (>6 g VS kg−1 inoculum day−1).
