The phrase "at half decrease" is not correct and does not convey a clear meaning in written English.
It may be intended to describe a reduction or decrease by half, but the phrasing is awkward and unclear.
Example: "The temperature will be at half decrease by the end of the day."
Alternatives: "reduced by half" or "cut in half".
For adsorbed/desorbed proteins, the elution peak showed similar results: "width at half height" decreased to 45% while the over-all width of the peak decreased by 28%.
It was shown that the position of main kesterite band (286 and 335 cm−1 for CZTS) shifted to the high-frequency region by 2 cm−1 and its full-width at half maximum decreased by almost two times (for the 286 cmodemode).
Figure 3 shows that the widths of the nonlinear peaks, estimated by the full-width-at-half-maximum (fwhm), decrease as the incident QCL power increases.
The Hispanic-white score gap at that level was also cut in half, decreasing from 41 to 21 between 1975 and 2011-2012.
However, the G peak position decreased from 1588.2 to 1582.2 cm−1, the width of the G band at half maximum intensity decreased from 46.3 to 28.9 and that of D band from 46.9 to 36.7 cm−1 from core to skin after HTT at 2500 °C.
The large full width at half maxima (FWHM) and decrease in intensity of the peaks with increasing co-dopant concentration suggest the effect of Nd3+ and Li+ doping on CdS crystallinity.
The realigned images were spatially normalized to the standard EPI template, resampled to 3×3×3 mm3 and smoothed using an 8-mm full-width-at-half-maximum Gaussian kernel to decrease spatial noise.
In addition, as the deposition power increased from 75 to 150 W, the full width at half maximum (FWHM) values decreased from 0.417 to 0.314, as shown in the inset of Figure 5.
For radial chromatography, the decrease in "width at half height" at Height Equivalent of Theoretical Plates (HETP) measurements was 40% while the decrease of the over-all width of the peak was 27%.
The (111) peak center shifts to a larger angle, and the full width at half maximum of the (111) peak decreases greatly, indicating a considerable decrease of defect density in the films.
