Sentence examples for at each array from inspiring English sources

DNA methylation at each array probe was tested for association with oJIA using RUV (Remove Unwanted Variation) together with a moderated t-test.

Mathematically, averaging the TFDs obtained at each array sensor amounts to taking the trace of the STFD matrix [18, 22, 23].

The incident vectors of the shockwave at each array station were estimated by an F-K spectrum and indicate good agreement with those predicted.

For simplicity and without loss of generality, let us consider a uniform linear FDA (ULA) which radiates at each array element identical waveform signal, but with a frequency increment Δ f Hz as shown in Fig. 1.

To determine which probes overlapped differentiated polymorphisms, we computed a t-test p-value for between soil types at each array probe; the distribution of p-values for probes with a perfect match in the draft A. lyrata genome is shown in figure 3.

The pyrosequencing and data analysis were performed in a PyroMark Q24 System version 2.0.6 (Qiagen) following the manufacturer's instructions.> The methylation status at each array probe was established by analyzing the distribution of b-values for all samples and CpG sites and transforming data into discrete values.

Sample files were then imported into GeneSpring (v11; Agilent), negative raw values were set at 1.0, each array was normalized by intensity-dependent Lowess (Agilent; [ 77]), and a baseline to median transformation of normalized expression values was performed per gene (Agilent).

600 ng of Cy3-labelled cRNAs were fragmented and hybridized for 17 h at 65°C to each array using the Gene Expression Hybridization Kit (Agilent Technologies) and a gasket slide with a 8 microarrays/slide format for sample hybridization to separate each sample in specific sub-arrays of the 8×15 K format.

Each gene was printed at least twice on each array, each array had two channels, and at least two hybridisations were conducted for each condition.

Satoh et al. (2001a, b) carried out array microtremor measurements in Sendai and nearby cities to obtain the deep S-wave velocity structures inside the Sendai basin, and the earthquake ground motions were also measured at the center of each array.

In order to maximize the SNR at the main receiver, each array element adjusts its transmitted signal using a complex, individual beamforming weight w m = 1 M e − j ϕ m, ϕ m ∈ Q, Q = ( 2 n − 1 ) π 2 N : n = 1, …, 2 N, (4).