The phrase "at a given strain" is correct and usable in written English.
It can be used in contexts related to materials science, engineering, or any field discussing stress and strain in physical systems.
Example: "The material exhibits a specific yield strength at a given strain, indicating its ability to withstand deformation."
Alternatives: "at a specific strain" or "under a certain strain".
The average value and deviation of crack width at a given strain can be calculated to facilitate durability design.
The fracture loads predicted using either model were in reasonable agreement with the measured forces at a given strain rate.
FPMs resemble natural tissues in their exponential dependence of stress on strain and linear dependence of stiffness on force at a given strain.
A lower flatness ratio led to an increase in stress at a given strain level, i.e. the material appeared to be stiffer than it truly is.
The total area of delamination has been determined by the delamination area ratio (DAR), a measure to quantify the delaminated area at a given strain.
For this system it is found that temperature does not significantly affect the spacing of film cracks in the steady state, at a given strain rate.
The quantity R0, the ratio of the scattering at zero angle for a given strain to that at zero strain, decreases very rapidly in the strain range 0 2.
Under quasi-static loadings at low temperature, for a given strain rate range, viscous effects can be neglected, but only a few experimental results are available to model the behaviour of an adhesive in a bonded assembly accurately under realistic loadings.
At least 30 cultures of a given strain were grown from inocula of approximately 1,000 cells for each fluctuation test.
Here, EBSD-assisted slip trace analysis is utilized to determine qualitatively the relative activities of basal, prismatic and pyramidal systems in the three microstructures under scrutiny following tensile deformation to a given strain level at ambient temperature and quasi-static rates.
By scanning the continuously cycling sample, a complete crystallinity map at any given strain phase angle was obtained.
