Sentence examples for at a given peak from inspiring English sources

This is given by the Eurocode 8 elastic response spectrum, scaled at a given peak ground acceleration and account for the position of the sub-service within the building.

Airway patency was indirectly assessed by measuring expired tidal volume (Vte) by using the plethysmograph at a given peak inspiratory pressure over PEEP (PIP/PEEP) [ 16].

The algorithm, called "MEPSA" (multiple excess peak search algorithm), essentially scans the time series at different timescales by comparing a given peak candidate with a variable number of adjacent bins.

Because the dependence of the PL intensity on the excitation density can be easily measured for a given UC PL peak, the UC QY for a given peak at any excitation density can be determined by referencing to a quantified UCQY at one particular excitation density.

The FDR is estimated using a Monte Carlo simulation, in which random locations are repeatedly generated for the reads and the number of peaks at a given height threshold in the randomized data is divided by the number of peaks observed at the same threshold in the real experimental data.

Scatter plots and Pearson correlations with Pearson p-values were obtained by calculating the log2 values of read densities normalized to the control at the given peaks or around ENSEMBL transcription start sites.

It has to be noticed that, at a given power, the peak pressure of a bifrequency signal is 2 times higher than the one of a monofrequency signal, as can be seen on peak pressures of the signals in Figure 1.

We also calculate the power spectrum which gives the intensity of fluctuations at a given frequency; a peak in the spectrum indicates noise-induced oscillations [ 35], a phenomenon which is of importance in biochemical networks responsible for biological rhythms such as circadian clocks [ 36].

To calculate the Msl1, Nsl1, or Pol II enrichment at a given gene either the peak tag density of the nearest peak to the TSS (in a region of +2 kb), was obtained through MACS14 (Zhang et al., 2008) or the total tag density around the TSS (+2 kb) was taken.

Pre-loaded and over-compacted materials sheared at reduced normal stress gave peak coefficients as high as 0.80.

An analogy is encountered in QTL mapping, when QTL inference is related to the peak area of a QTL, rather than the peak height at a given position.