The phrase "at a given flowrate" is correct and usable in written English.
It can be used in contexts related to fluid dynamics, engineering, or any situation where flow rates are relevant.
Example: "The system operates efficiently at a given flowrate, ensuring optimal performance."
Alternatives: "at a specified flow rate" or "at a particular flow rate".
A parametric study was conducted to determine the optimum control parameters, namely those that deliver the largest increase in fan pressure for a given flowrate.
In the annular flow regime, as the liquid flowrate is increased at a given gas velocity, a different form of annular flow known as wispy-annular flow is observed (Hewitt & Roberts, UKAEA Report No. AERE-M2159; BArgonnergoNational LaboratorytoReportort, No. 7093).
The curves developed in the multi-objective optimisation can provide not only the ability to determine the CO2 capture rate to maximise the profit at a given time due to fluctuating electricity prices, but will also provide the optimum solvent flowrate and lean loading to achieve that maximum capture rate for a given net power.
Graphical and algebraic targeting techniques are developed to identify the minimum chilled water flowrate needed to remove a given amount of heat load from the CHWN.
For a given production rate, the concentration in the downstream MPS of the production location will be maximized by increased inter-MPS flowrate and reduced medium volume of the downstream MPS.
The stored methane could be continuously released at a constant flowrate for the whole discharging process.
It was concluded that both prototype cDMAs, operated at a sheath/aerosol flowrate ratio less than 15:1 and with a polydisperse aerosol flowrate of 1.0 lpm, achieved sizing resolution comparable to that offered by Nano-DMA.
After careful investigations, a modification was tried in which the peristaltic pumps were exchanged and consequently a highest hydrogen stream of 860 ml/min from 25 wt% NaBH4 was obtained at a solution flowrate of 1.25 ml/min.
The optimization of cutting angle is around 35° for 10 CFM, and it is reduced to 15° at a larger flowrate of 20 CFM.
The feed was circulated at 240 mL/min and permeate was collected at a constant flowrate of 3.5 mL/min, until the target concentration factor was achieved.
