The phrase "astm test" is correct and usable in written English.
It can be used when referring to a specific test or standard set by ASTM International, which is an organization that develops and publishes voluntary consensus technical standards for materials, products, systems, and services.
Example: "Before we proceed with the project, we need to conduct an ASTM test to ensure the materials meet the required standards."
Alternatives: "ASTM standard test" or "ASTM procedure".
Properties were measured in tension, shear, compression, and flexure using standard ASTM test methods.
The test results are also used for assessing the newly developed American Society for Testing and Materials (ASTM) test standard, E2760-10 for creep fatigue testing.
The experimental programme included an evaluation of impact damage resistance and tolerance according to ASTM test methods, characterisation of induced damage by ultrasonic testing and quantification of the effects on the vibration response.
To demonstrate the capability of numerical procedure when applied to a low-velocity impact problem, numerical results are compared with the experimental ones obtained in a test campaign performed on 44 laminates specimens subjected to an out-of-plane and concentrated impact event, according to ASTM test method.
A new method of using chemical kinetic reaction modeling to predict the Research Octane Number (RON) and Motor Octane Number (MON) of single component fuels and fuel mixtures is described and illustrated via comparisons between computed and experimental values obtained using the well-established ASTM test procedures in a Cooperative Fuels Research CFRR) engine.
The Al reduction technique (ASTM test method D1354-76) was employed to analyze the TiO2 content of the samples.
First, the mechanical properties of the composite were determined experimentally using the ASTM testing standards.
Unfortunately, current ASTM testing standards used to determine these properties were designed prior to the advent of bioresorbable materials for cages.
Some current ASTM testing standards, notably those on erosion testing, account for the non-linear behavior of wear, but others, such as tests for sliding wear, usually do not.
Most documents related to standards, testing, or approval of reinforced plastics refer to a wide range of ASTM testing procedures, which are often used in Europe, the Middle East, Africa, the Pacific area, as well as in North and South America.
The properties of the fresh and hardened RCA and CRCA were investigated according to ASTM tests, and the properties of CRCA were compared with those of CCA.
