The phrase "as the activator" is correct and usable in written English.
It can be used in contexts where you are describing a role or function of something that initiates or triggers a process.
Example: "In this experiment, we will use the enzyme as the activator to facilitate the reaction."
Alternatives: "in the role of the activator" or "serving as the activator."
In R6-1, thenzymeme regulates the activity of the product as the activator of two processes – unknown inactivation (p1) and unknown activation (p2) – in which the product takes part.
Impedance aggregometry using thrombin receptor activating peptide as the activator allowed differentiation between good and poor prognosis, although with a lower odds ratio (OR 3.1).
Alternatively, for measurements in which the 532 nm light source was employed to illuminate fiducial markers (see below), a 568 nm light source was used for activation of probes with Cy3 as the activator.
These molecules mediate activation of many key transcription factors, such as the activator protein-1 complex, which then facilitates induction and transcription of the relevant proinflammatory genes, such as cytokines, chemokines and matrix metalloproteinases [ 12].
Further experiments, therefore, were needed to identify the activating sequences in the ERBB2 promoter, and the molecules that bind them, such as the activator protein 2 (AP-2) transcription factors.
Herein we report the preparation of N-doped porous carbon via pyrolysis of microporous polyindole with KOH as the activator under N2.
The activity of Rho GTPases is controlled by two families of regulators, guanine nucleotide exchange factors (GEFs) as the activators and GTPase-activating proteins (GAPs) as the inhibitors.
For the prediction of diagnosis, as well as outcome of severe sepsis collagen, ADP and thrombin receptor activating peptide can be used as the activators for impedance aggregometry.
The mixture calculations including mix water, were made based on the optimum amount of activator needed to activate the pozzolan with no additional water added as the activators were already in solution (Bondar et al. 2011).
As the activators randomly replace Y3+, it can thus be said that more activators would reside on (222) to yield significantly enhanced emission.
The optimal preparation conditions of WSAC were as follows: the activator mass fraction being 40%%, activator time being 60 min, and activation temperature being 450 ºC.
